🔌 SUPERNIGHT(TM) RGB Signal Amplifier for SMD 3528 5050 LED Strip Light, 12V DC 12A Repeater Review

Only worked for about a minute then the blue light channel stayed on regardless of the input signal. Even if I disabled color input. The item has been returned and returned.

Requires an enhancer to finish another accent wall 40ft away. Bought and plugged straight into my light bar with bulbs and adapters pre-installed - perfect. ATTENTION: The required power supply unit is not included in the scope of delivery! Make sure and buy the required power adapter.

Does exactly what it's supposed to do, the device is just a triple power MOSFET relay. Note that the label on the device says +RGB, while in the example the wires have +GRB (which is most commonly used for strip lighting) and G/R crossed at the terminal blocks. Actually, the order doesn't matter as long as they are the same at both ends.

If you install RGB (4-pin) LED strips and want to run them long enough, you will notice that the color does not change towards the end of the strip. up to the beginning of the band. This is because the power wears off when it reaches the end. This product solves that problem. Simply install this product about halfway down your lane and it will power the rest of your lane. You can still drive the entire band as usual, this is just a performance boost and doesn't affect overall functionality.

I used this to extend some LED lights in my kitchen for a lighting project I was doing for LEDs above and below a cabinet. It worked great for increasing power levels where needed because once I was done with my attic and floor and catching extension cords I had a couple of long runs. I can't compare it to any other brand but I can say it does its job perfectly!

Passed 2 of these because I thought I was - they just don't work consistently. The lights are bright, they're just not the same color as the other segment of the light. The fade worked for a while, then stopped. Not expensive but save your money. I ended up buying https://www.amazon.com/dp/B06Y68NZ4Q/ref=cm_cr_ryp_prd_ttl_sol_46 which seemed more reliable to me.

If you are installing RGB LED strips (4-pin) and want to use them over long distances, you will find that the color towards the end of the strip is not as accurate as it is is at the beginning of the strip. This is because the power wears off when it reaches the end. This product solves that problem. Simply install this product about halfway down your lane and it will power the rest of your lane. You can still drive the entire band as usual, this is just a performance boost and doesn't affect…

Thoughtful design, nice all metal body, mounting end plates, 8 countersunk screws, 4 on each end. Top quality detachable connectors on each end, well-made 4-wire pigtails and molded 4-pin connectors on each end. Other than that it was a disappointment. I bought "2 packs", huge value - just to work. I EE and decided to find out. The clever design uses 3 EL817 optotransistors to sample incoming RGB PWM signals from another (lower power) LED driver block while providing 5000V isolation between the