🚀 Unleash Your Vehicle's Power with the Superwinch 1145220 Terra 45 Winch Review

Seems like Superwinch has listened to the feedback as the winch now comes with a protective cover for the circuit breaker. Installation went smoothly, the only issue was the rail didn't fit my RZR (too wide). I drilled some new holes and it works and looks good. For those who say wire isn't enough, just swap Yellow/Blue and Red/Black so it reaches the front of your car. Colors don't matter if you connect them correctly. My RZR 4 XP1000 had a lot of cables, I only had to swap two sets. So far…

*Update. I installed this on a 2019 Outlander XMR. Used it twice to pull myself out of the mud using the tree as an anchor. The second time I used that part of the cable it broke, it looks like 3-4 pieces of cable were coiled up and one of them broke. The winch is open and allows dirt to get in and onto the cable. Every time you use this you basically have to pull it out completely and hose it down with water before you can use it again. Tried to use it for the third time this weekend and it…

I've been looking for something that can withstand underwater, sand and mud for an ATV for a long time and finally settled on this one. This is my first time owning or even using a winch but I followed the instructions strictly knowing they are easy to break. The first thing that struck me was how difficult it was to pull the cord out so it wouldn't snag on itself when it let go of the cord. There seemed to be too much wire on the spool. The second time I used it, it came back on its own…

I ordered this winch a few months ago and finally got around to using it. The problem I found was that I noticed a black "stickiness" on the sides of the reel and I couldn't wrap the cord loosely. I loosened three screws and removed the coil. I found that the o-rings on the sides of the reel were dented all over into a gooey mess. I emailed Superwinch but didn't get a reply so I went to their website to give them a call. I ended up chatting with someone and they said someone from the support…

Buy the correct winch mount and dash switch first. Instructions are not unit specific, but must be followed. #one. Remove the bumper, install the winch bracket, winch and fairlead, hand launch rope/cable as instructed before reinstalling the bumper. #2. Remove the upper instrument panel, there are 3 marks for the wired remote control in the middle of the lower part of the panel, drill according to the instructions and install the connector. If you purchased a dash switch, remove the center dash

This review is for a Superwinch Terra 35. Per KFI fitting instructions; I removed the front bumper and some skid plate bolts. According to the instructions, only a few front underbody protection screws should be unscrewed. I had a lot more freedom by removing two more bolts under the engine, which allowed the skid plate to move freely and get out of the way. When I removed the bumper I found that the two metal tabs on the bracket did not fit on the outside of the two chassis and bumper points…

I installed a Terra 35SR winch on my '21 BF750 EPS using a KFI Brute Force 650 n 750 mounting plate purchased from Amazon. https://www. amazon.com/gp/product/B0027UTJHQ/ref=ppx_yo_dt_b_asin_title_o04_s00?ie=UTF8&psc=1 The winch instructions were pretty easy to follow, but obviously they don't give you specifics for your ATV that you should have a representation of what you're doing around getting it right. The hardware and cables that came with it are all I need to install. The cables are quite

I bought a Revain 3500 winch because I burned a lighter winch on my ATV. Without a doubt I would definitely recommend at least a 3500 winch with synthetic rope. Once you go plastic, you'll never go back to wire rope. Wires, or rather tethers, are designed to take heavy loads and give you enough that it can be difficult to hide as they aren't very flexible. I followed the instructions and found that the winch wasn't lifting from the bottom like it should. After double and triple checking my…

Superwinch Terra 35 Synthetic Bought from Revain.Com. The box was surprisingly small but I think it's just a 3500lb winch. I bought it for my Honda Pioneer 500. I bought the KFI winch mount separately. Honda would sell me a Warn winch for three times the price and charge me $300 to install it. I figured I could install it myself and get Superwinch for 1/3 the price of Warn. I have had several ATV Warn winches. They've never let me down, but I've never been hard on them. I have chosen not to be…