🔌 ESUPPORT 1 Pin Way Car Auto Waterproof Electrical Connector Plug Socket Kit - 5-Pack for Marine Use Review

They perfectly match my motorcycle led project. The wire was of good quality. They were a bit difficult to take apart at first, but after a few cycles it became a little easier to take apart and put back together. I can't comment on the waterproofness as it's under my seat. I opted for waterproof to be on the safe side.

Skip This And Shop The Best Set. Did it work? Yes. Some profits are already separate and therefore useless? Yes. I only needed 2 so I was lucky this 5 pack had "only" 2 with the wires already disconnected. The rubber insulation between the pin and socket is badly bent/broken on all of them as well. As a matter of fact. It's just cheap junk.

I needed to replace the female ends of my wires with spools, I wasn't sure if these female ends would fit but bought them anyway. I kept getting the misfire code and fixed everything I could except the wires. I welded and soldered the wires to the worst and the engine light went out and the idle got a little smoother. two left. They worked!

I used these on my sailboat to connect the wiring from my mast to the wiring in the boat. I've tried using "marine" fittings in the past, but salt water always seeps through and corrodes the fitting. That is amazing! Maybe a bit ugly, but they stay tight and salt water doesn't corrode the connectors. Dude, I'm glad I solved this problem.

They are small, less than an inch wide and about 1.5 inches long, which is just right for my needs. The wires are short, they are about 4 inches long. Better at least 6 inches and pre-polished, but these will work. Make sure to use "shrink spaghetti" :-) - 1/8" tubing works well. Can't be taken apart without ruining things, and you'll have to solder wires if you don't have pins. which most of we don't have on hand because we buy these things.

Two out of five were bad. I traced it with an ohmmeter and found that I had no circuit from at least one wire on each of the two failed sockets to the pins in this connector. Sometimes it was possible to get a chain by putting the wires in the connector, but I need a very reliable connector where they enter my RV. The plastic parts of the plug appear to be well made and the seal is very strong and seems to keep out dust and moisture very well, but what's the point if the electrical connection…

at the moment I'm only giving 4 stars because I don't yet know how waterproof they actually are, but the design for the Chinese made connection kit seems to be of a pretty high quality. Plugged in and unplugged a few times, no problem, I used two of these in my overhead console project to quickly remove for maintenance and two to replace the crappy spade connectors my two front LED light bars came with . Satisfied so far, casting of the body is fine, no mold flashes or other deformations…