Header banner
Revain logoHome Page
sydien pillow block flange bearing logo

Sydien Pillow Block Flange Bearing Review

3

·

Poor

Revainrating 2.5 out of 5  
Rating 
2.7
🔩 Bearings, 🔩 Power Transmission Products

View on AmazonView on ЯM

Media

(4)
img 1 attached to Sydien Pillow Block Flange Bearing
img 2 attached to Sydien Pillow Block Flange Bearing
img 3 attached to Sydien Pillow Block Flange Bearing
img 4 attached to Sydien Pillow Block Flange Bearing

Description of Sydien Pillow Block Flange Bearing

⭐Package Content: 4Pcs x 8mm Bore Diameter Pillow Block Bearing. ⭐Dimension: Bore Diameter: 8mm/ 0.31"; Total Size: 55mm*16mm*29mm/ 2.16"*0.51"*1.14"(L*W*H); Mounting Hole Distance: 42mm/ 1.65"; Mounting Hole Size: 5mm/0.2". ⭐Setscrew locking collar for secure attachment to guided shaft. Self-aligning pillow block bearing. You can adjust or replace the bearing easily. ⭐Two-bolt housing with ball bearing insert for ready-to-mount installation. If the bearings you receive are not flat, you can simply tap the bearings with a hammer to adjust them to the correct Angle. ⭐Widely used in various of machinery, especially in food machine. Can be used into conveyering systems, film processing machinery, spin machine, printing machiner.

Reviews

Global ratings 3
  • 5
    0
  • 4
    1
  • 3
    1
  • 2
    0
  • 1
    1

Type of review

Revainrating 3 out of 5

They are well dressed for fitted bearings

Re 8mm bearings. I use an 8mm diameter rod that is 7.98mm long. 2 bearings slide well enough, 1 needs pressure to make it slide and 1 doesn't move. I know they are only $9 for 4 so don't expect too much. But be careful, it's very small to make a mistake in the size of the bar and even in this case a little sanding may be needed.

Pros
  • Decent performance
Cons
  • Other

Revainrating 4 out of 5

Quality is good but METRIC. NOT SUITABLE FOR US STANDARD STEEL RODS.

These are quality bearings but they are METRIC and will NOT fit US standard steel bars. The item description says "1/2" diameter, but the buy button says "12mm". They are actually 12mm, not 1/2" (which is roughly 12.7mm). So my 1/2" steel rods need to be sanded, luckily only on the ends.

Pros
  • Pretty impressive
Cons
  • Drill Bit Pack

Revainrating 1 out of 5

Unsuitable for all but the harshest of applications

Anyone with knowledge or experience of bearing applications in a mechanical device is aware that bearings of this type (inexpensive) are not designed for high accuracy or long life. lifetime. However, it can be expected that the bore and ball raceway will be sufficiently concentric that no noticeable runout or "bottlenecking" occurs under load. They had both.

Pros
  • Easy to read control panel
Cons
  • There are new competitors