Header banner
Revain logoHome Page
πŸ”¦ d&d brand h system mr16 low voltage track lighting fixture white htc-r10-wh (head only - no bulb), white - enhanced seo logo

πŸ”¦ D&D Brand H System MR16 Low Voltage Track Lighting Fixture White HTC-R10-WH (Head Only - No Bulb), White - Enhanced SEO Review

6

Β·

Average

Revainrating 3.5 out of 5Β Β 
RatingΒ 
3.3
πŸ’‘ Ceiling Lights, πŸŒ€ Lighting & Ceiling Fans

View on AmazonView on Π―M

Media

(4)
img 1 attached to πŸ”¦ D&D Brand H System MR16 Low Voltage Track Lighting Fixture White HTC-R10-WH (Head Only - No Bulb), White - Enhanced SEO
img 2 attached to πŸ”¦ D&D Brand H System MR16 Low Voltage Track Lighting Fixture White HTC-R10-WH (Head Only - No Bulb), White - Enhanced SEO
img 3 attached to πŸ”¦ D&D Brand H System MR16 Low Voltage Track Lighting Fixture White HTC-R10-WH (Head Only - No Bulb), White - Enhanced SEO
img 4 attached to πŸ”¦ D&D Brand H System MR16 Low Voltage Track Lighting Fixture White HTC-R10-WH (Head Only - No Bulb), White - Enhanced SEO

Description of πŸ”¦ D&D Brand H System MR16 Low Voltage Track Lighting Fixture White HTC-R10-WH (Head Only - No Bulb), White - Enhanced SEO

Compatible with H system single circuit 3-wire track ONLY. (Check the fixture back plate. There should be 2-clip terminals on 1 side and 1 clip terminal on the other side. 15/16-inch if measure from tip to tip). Please match polarity when installing the fixture on track. The 2 metal tips have to be aligned with the 2 wires on the track. Do Not work on J or L system tracks. 12V low voltage MR16 GU5.3 ceramic socket. Accepts MR16 Halogen (50 watts max.) or MR16 LED bulbs (8-watts higher, or the light might flicker). Bulb NOT included. Pre-installed electronic transformer & MR16 lamp holder clip included. ETL Listed. Rated for Indoor use or Dry locations.

Reviews

Global ratings 6
  • 5
    3
  • 4
    0
  • 3
    1
  • 2
    0
  • 1
    2

Type of review

Revainrating 1 out of 5

Faulty product in track lighting

Arrived quickly. Ease of installation. Two of the three units failed on the same day. I wrote to the supplier and received no reply. It looks like it was a waste of money.

Pros
  • There's something in there
Cons
  • Some defects

Revainrating 5 out of 5

Works great for me.

2 of 3 lamp heads on my 20 year old Hampton Bay rail attachment died and it was impossible to find replacements from the manufacturer and major home supply stores. Luckily I found them at AMZ, they fit perfectly and work.

Pros
  • Sturdy construction
Cons
  • Too long to wait

Revainrating 3 out of 5

Just a problem best with track lighting

Honestly can't tell if a new bulb or lamp is interfering with my TV, never had a problem with other bulbs and when I take them off track hear the noise on. I honestly can't estimate the cost.

Pros
  • Expensive but decent
Cons
  • Update available

Revainrating 5 out of 5

Works with 50W LED bulbs (dimmable recommended)

Four purchased. Everything worked great. Using a Covered Porch - Not a humid environment, but definitely a humid environment. Previous similar lamps have served in these conditions for more than 15 years. Please note that you need "L" series track.

Pros
  • Best
Cons
  • Volume

Revainrating 5 out of 5

Works great: lights and ceiling fans

I tried replacing one that sometimes worked and sometimes didn't. I found this one which was similar and thought I'd give it a try. Success. I also use LED bulbs for this so that I don't have to change them for a long time, save money in the long run and don't produce any unwanted heat. This should extend the life of the lamp by some time, much longer than if I were using a halogen bulb.

Pros
  • Easy Install
Cons
  • Modern

Revainrating 1 out of 5

Warning! Dangerous product - potentially deadly!

I bought 28 for a project and at least 1 of them was defective. The defect resulted in a failure that could have been fatal under other circumstances. The fault was discovered after power was applied to the circuit and shortly thereafter the breaker was found to have tripped. If the circuit were left closed or if someone touched the light fixture directly, they would be electrocuted. After the device was found to have tripped the switch, it was removed. Dark soot was visible on the outside of…

Pros
  • Looks great
Cons
  • No mold required