🔌 Optimized for SEO: Pack of 10 Taylor Cable 46052 LT1 180-Degree Black Spark Plug Boot with Terminals Review

Boots are very difficult to mount on 8mm Taylor wire. A ton of fat. Good luck trying to separate them. Can work well with 7mm. But not suitable for 8mm Taylor silicone wire at all. Sliding silicone on silicone. I fixed it and was able to get it working. I sharpened the boots with a 3/8 shaped drill bit. The boot is still tight and with a little boot lube it slides right in. This is not necessary for a new part. But it works.

These fit the GM style horizontal distributor cap that normally comes with Vortec V8 engines and 1995-2007 V6 engines. This is a great kit. Note that larger diameter wires will not fit into these rubber parts. You will need to drill them out with a drill to fit larger diameter wires. It's worth the price and it's nice to have extras for friends who are willing to pay a small coin for them. You won't typically find these in car dealerships, so keep them.

I bought these Optispark spade lugs with Taylor cable 73251. I wanted to route the cables in a different route than the factory one as I have long pipe connectors. To install. Even after the shoes and wires were fully lubricated, they were still quite difficult to install. I even used a Taylor crimping tool. After I installed the boots, they worked flawlessly. I had an audible double click from all 8 boots when I installed them on the Optispark manifold.