TCE ATZ830026XU Hydraulic Profile Capacity Review

was a gift so I assume everything works fine as I have not heard any complaints. Many bad reviews about this product were a result of poor packaging and rough handling during shipping. but this time it wasn't.

Stands are supplied without a locking pin. I called the manufacturer 4 times! I got stopped every time. The recording told me to leave a message, they will call me back! If more than a week has passed since the first message. No Answer. I'm not sending them back. Do not buy

This jack has a 3 ton jack sticker, weighs 66 pounds, has an ultra low profile and is a two piston jack as advertised. However, mine came all black, not black and BLUE as advertised in the photos. The photos also show the scratch guard for the jack handle, but mine didn't come with foam scratch guard. If a company inserts images, the product they deliver must reflect the same. Thank you for reading.

Bought these to replace some tweeters that weren't on the recall list but I still don't trust them. I depend on it. They are very well made, the welds are almost perfect. This locking pin seriously reduces anxiety, no matter how I smack the handle I know it won't dislodge and park the truck on my skull. I like them enough that I've bought an identical but rated 3 ton kit when standing under one of my cars and don't need the height/lift capacity of the 6 ton blocks. Safety is the top priority.

These stands are impressive, but they're huge. I'm not even sure I can fit them under any of my cars (a Ford Escort and two Mercedes) and won't know until tomorrow morning. I bought these based on some advice on the internet about the capacity but I never stopped thinking about the height. In the center of the saddle, fully stowed, they are 15 inches tall while my 3-ton is 11. My 3 tons look like toys standing next to them and I suspect they are more for higher profile cars and trucks than…

Well packaged. Be careful when removing the clip holding the handle down for transport, but when I pulled it off it went off like a rocket and I never found it. I suspect he flew over my 6ft wooden fence into the neighbors yard, it might be good to wear goggles for the job. I removed the oil filler cap and turned the handle counter-clockwise, pumped the jack several times to bleed the air out of the jack, and used a screwdriver to bend the rubber plug a little to let the air out. Outside. I…

Like many others at the time of this review I have been diligently searching around to find a set of 6 tonne replacement stands after mine was recalled by Harbor Frieght. Unfortunately, many of these recalled/failed stands turned out to be made by the same company. So the fees were meager. I had my eye on a pair other than this one but didn't have time to make a decision before they sold out. Seems to be a blessing in disguise as it's more than I expected. They are very well built and the…

These jacks look great when viewed online. I didn't try them because I knew straight away they were going to be sent back. They only arrived in the box they are in, not another box with protective shipping packaging. The box they came in was dented, the tape had ripped off, and it had at least one hole through which one of the pins might have been missing. At the bottom of the box was what appeared to be thick paper. The main part of the two stands was pressed against each other - there was no…