🚗 TECKWRAP 1ft x 5ft 5D Glossy Black Carbon Fiber Vinyl Wrap Film for Cars - Bubble Free Air Release, Automotive DIY Decals Review

Photo Proof. I've used this for my front and rear fenders, as well as trimming my helmet and pistol grips. This material is of high quality. I would never recommend a DIY vinyl project without a heat gun. You need a heat gun with every wrap job if someone tells you they're lying. but this stuff looks amazingly thick, but not too thick. well formed at the edges. You just have to be patient. it's not lile to grab a spray can. You should actually mark your time with the winding job.

I wanted to pack some parts on my bike. tried the hardest part on my bike first. Unfortunately, this coating is very difficult on curved surfaces. I tried dry grip first and ended up just overdoing it with the packaging. A new piece tested with water spray adhesion made it worse and didn't stick at all. If your only packaging is a flat surface, then go for it. Next. much luck. To be honest, I prefer to paint my bike with a chameleon paint or something similar than to use this film. The foil…

This wrap looks great on my Mazda 3 interior. This film applies well and actually sticks as intended without the use of nasty adhesives. It's just as easy to take off as it is to put on. Long term update: More than 6 months later the film still looks exactly like the photos. No blisters, fading or peeling when this film is applied correctly. 1 year later: still looks as shown; does not fade and is scratch resistant. The only area where it rises is a narrow corner where I ruined the adhesive by…

I got a 5D gloss roll. The print on it is very nice. The material is thin. There was a crease in it about 6 inches. So up until this section I immediately had to cut and discard material. Damn. Then I tried to put it on the cover of the car's fuse box. It didn't stick. I thought maybe the surface wasn't clean enough. So I tested it on various other surfaces including inside a car and on a mirror cover. I've done vinyl before, but the stuff just didn't stick well. This meant there was no way to…