Header banner
Revain logoHome Page
πŸ”’ thick d-shaped rubber seal by trim-lok logo

πŸ”’ Thick D-Shaped Rubber Seal by Trim-Lok Review

3

Β·

Average

Revainrating 3 out of 5Β Β 
RatingΒ 
3.0
πŸ› οΈ Seals & O-Rings, 🚰 Hydraulics, Pneumatics & Plumbing

View on AmazonView on Π―M

Media

(4)
img 1 attached to πŸ”’ Thick D-Shaped Rubber Seal by Trim-Lok
img 2 attached to πŸ”’ Thick D-Shaped Rubber Seal by Trim-Lok
img 3 attached to πŸ”’ Thick D-Shaped Rubber Seal by Trim-Lok
img 4 attached to πŸ”’ Thick D-Shaped Rubber Seal by Trim-Lok

Description of πŸ”’ Thick D-Shaped Rubber Seal by Trim-Lok

EPDM FOAM RUBBER SEAL: Trim-Lok D-Shaped Rubber Seal drowns out noise, eliminates vibration, and protects your vehicle, boat, or home from outside elements. MANY APPLICATIONS: Durable Trim-Lok Foam Seals can be used for marine, automobile, and home cases – providing hatch, window, and door seals for cars, trucks, RVs, trailers, boats, and more!. WEATHER-RESIST: These rubber D-seals provide excellent resistance to water absorption, ozone, sunlight aging, low temperature, and compression set. General temperature rating of -20Β°F to +158Β°F. It is a reliable weatherstrip seal for many applications. EASY INSTALLATION: Adhesive-backed D-shaped seals made with two options: BT (3M) tape is a high-strength automotive-grade tape, while HT tape is a general-purpose pressure sensitive tape. Both offer quick, easy, and efficient installation. DIMENSIONS: This weather-stripping adhesive rubber seal measures .50” in height, .50” in width, and is 25’ in length. It is also available in a variety of edge thicknesses and can be cut to fit your specific application.

Reviews

Global ratings 3
  • 5
    1
  • 4
    0
  • 3
    1
  • 2
    0
  • 1
    1

Type of review

Revainrating 5 out of 5

It appears to be the same as my original gasket.

I've been recommending this since my first install. I highly recommend removing the old strip, glue, and dirt before sticking the new one on. I did 3 slide outs in about an hour. This made the slide out seat the way they were used to, with a clearance of about 1/8 inch from the slide hitting the side of the RV. Please pay attention to where the current spacer is, mine is on the drawer next to the inside corner, not on the edge of the drawer, otherwise the drawer would be too far away from the…

Pros
  • Hydraulics, Pneumatics and Plumbing
Cons
  • Expensive

Revainrating 3 out of 5

It appears to be an exact replacement for the 1998 Winnebago Chieftain sliding seal.

Replaced the o-ring on a 1998 Winnebago Chieftain. Profile appears to be an exact replacement. While not exactly the same profile as the cab door seal, it effectively replaced that seal, which proved to be a very great addition. Given the large reel I have enough to replace damaged/worn sections for years to come. Easy to cut, apply (peel and stick) and once applied or pushed back the extension after two months of closure will not raise any areas. Will definitely buy again unless it proves…

Pros
  • Gaskets
Cons
  • Doubtful

Revainrating 1 out of 5

Two 12 meter sections taped together. NOT 25 feet long! - Very disappointed!

I spent all day removing the old seals from the sill end of our hybrid camper. It's finally time for a new filling. We unrolled it and started using it. 3 feet from completing my 15 foot rig. I found it was 2 PIECES of compressor, NOT 1 continuous 25ft piece like I ordered. Now it's glued to the van and I don't want to take it off and spend extra hours trying to remove the glue. BUT it will flow. So now I need to get some caulking glue and try to patch it together. That's very disappointing. I…

Pros
  • O-rings and O-rings
Cons
  • thin