🔌 Tyger Auto TG-HW2J001B Electric Wiring Kit for Jeep Wrangler JK Tow Hitch – 55" Length Review

This wiring harness fits my 2012 Jeep Wrangler Rubicon JKU perfectly. Installation took about 5 minutes and everything worked perfectly on the first try (all brake lights and turn signals). It was a lot easier than splicing the wires and I would recommend this to anyone with a JK/JKU.

I was amazed. Finally something that fits and installs perfectly and easily on my 2017 Jeep Saraha Winter Pack. The hardest part was finding the small holes on the Jeep frame to insert the plastic mounting pins that were already included/attached. Well made and the best price I could find. You will not be disappointed.

If you can use a screwdriver, you can install this product, just unscrew the driver's side tail light, plug and play, route the wires under the Jeep, and they even include clips that use existing holes in the frame to hold the suspension. I have an after sales bumper so I used a zip tie to keep it a little higher when I'm off-road. Overall great product, great price, fast delivery!

There was a bad connection, but if you stick it, it works fine. The bad connection was an issue and I'll have to fix it later, but I still gave it 3 stars because the product is great and very easy to install. It wasn't worth my time and effort to come back because I was out of town and had to do this work so I could tow the trailer. While it works I'll fix it later.

2016 Jeep Wrangler JK Unlimited Works perfectly, fits like factory. Save about $600 and install your hitch yourself without the dealer. Very easy installation. Ordinary hand tools. Get this with the Wiring Harness: TYGER Clutch & Cover Kit Custom Fit 2007-2016 Jeep Wrangler JK 2-Door & 4-Door Unlimited OE Style 2" Rear Receiver Tow Bar

Installation was a breeze. The JK taillights have 4 screws but only the outer 2 hold the light assembly to the jeep. Unscrew these screws, unscrew the bulbs and set the tail light aside. Pull the wiring out a little to ease access to the connector and disconnect by sliding the red locking tab and pulling apart. There is a foam insert at the bottom of the cavity in the tank. Take a knife and cut off enough to run the wiring through the tank. Once that's done, simply attach the wiring harness…

Wow, this hanger was the easiest accessory I've ever added to my Jeep! Simply remove the left tail light, the two right screws and pull out. Disconnect the tail light from the factory wiring harness, thread the new wiring harness through the hole so it hangs under the jeep. Insert the new wiring harness into the old one. Connect taillight to new wiring harness and reinstall. Now go down and pull the rest of the strap towards the clutch. They include pre-installed push-in clips that fit into…