🚽 Valterra T1041-1 Eccentric Tank Reducer - 3" Spigot x 1-1/2" Hub: Efficient Plumbing Component Review

Easy to install, used a board and hammer to slowly hammer it into place after removing the old cracked cap on my gray tank. I found a suitable hose clamp here and now it is completely dry in the compartment. Easy to repair by hand. Also recommend Valtera 1.5 inch relief valve, good products. I retrofitted and replaced all the gray lines on this cap and used an ABS street elbow and 2 Fernco fittings from a large orange box store. Better than new!

So glad I found this. Had to replace my RV Waste Tank (grey) and it worked perfectly. Note that it fits into the tank neck while the factory looked different. As a result, I miscalculated the length of the pipe. Here's a tip: clean the tank neck thoroughly and apply some PB Blaster to lubricate the fitting. At one point I thought I wouldn't make it, but in the end it worked. WD 40 works too, but not as well.

You know that feeling when you do something really stupid? So I had to buy one of these. I was driving our camper up a small hill and broke the septic tank fittings. Luckily they were empty. Could you imagine if they didn't exist? Fuuu! However, I needed one of these for a remodel and it was a direct replacement for my original part on my 2013 Forest River RV. From my last experience I was hoping this one would be a bit more reliable but it's the same as the old one. I'm setting up a seasonal…