Vertical router BOSCH GOF 130, 1300 W green Review

The plastic transparent nozzle looks flimsy, but has not yet cracked or warped, and it will probably be inconvenient to buy a replacement for it. But it is quite possible to replace it with a homemade one. Got pros: Delivery to the point of issue on time and in the full declared configuration. The device is quite reliable: it is used for a month, but almost constantly (almost daily). For the money, in my opinion, corresponds to the declared functions. It does not get very hot and does not emit…

I read reviews about this router and decided to write my own. 1) There is 1 copy sleeve (ring) in the set. For the American market, sold for an inexpensive large set of Bosch rings, including an adapter for threaded rings. 2) This is such a classic "average" router - the average power is relatively small weight. Comfortable to hold. If it had 12 collets, it would either cost more (like the Bosch GMF 1400) or weigh more, or both. There are large cutters for 12 collets, which he simply will not…

Add microtuning and replace the wire with a better one and the device will be the best in its price segment; how long it will last time will tell

They did not immediately issue a KKM check, but only a slip for payment by card. I had to return: the check was in the hands of the employee of the pick-up point ( Receipt tape (thermal paper!) With a very pale print, after six months there will be no trace of what is printed, even if this document is stored in the refrigerator: I had to make a copy through scanning it and then printing it on a printer, since only a check provides warranty service for the purchased goods.

blue bosh - took ie bosh! Its pros: he has a different engine, unlike the green one. I disassembled and drove both. This can be used to make a decking board until your hands get tired and your head spins. Just know to change the cutters, but in insta post buzz.) Has cons: well, a little - the absence of a microlift, but everyone clearly understands that an accuracy of 1 mm on wood and such a milling cutter is enough. Where are the hundredths and even tenths? This is not a lathe. Nevertheless…

Add 200-300 watts here, you could have 12 collets in this router. Even fine tuning can be scored. And if the above were delivered, then there would be a milling cutter number 1 for such a price. Took for 8k at the time.

Different pros: Solid, I will use it as an auxiliary router so that the collets are not rearranged, in order to save time Different cons: It didn’t fit all tasks, the 8 mm collet cannot work with certain cutters.