VViViD Sealing Finish Protector Squeegee Review

It works to keep the fender and door end from squeaking so this is a 5 star product for me knowing the dealer will ask for an arm and a leg to do the same with my car.

Poor adhesion and fogging under the clear film. Blown away when washing the car the day after installation. Lots of imperfections in clear mylar for you to see. Have been using 3M Clear Door Edge Guard for many years with no problems.

This was a big disappointment. The edges of the film were so badly cut that dirt from the cut fell behind the film when it was applied. I had to imitate it and found all the doors behind the film garbage. What a waste of time. Next time I'll try the regular 3M. dissatisfied with this movie.

Works well for straight lines, don't try curves. The glue also tends to ooze out, leaving a black goo around the edges. I was originally told to use this to seal the edges of the Vvivid vinyl but it makes a huge mess. Better to use 3M edge sealing brush. After about two weeks of sitting, the middle of the roll popped out and flipped all over the place as well, so I lost about half a roll as a result.

Bought this product to protect door edges. After receiving the product, it turned out at a glance that it was of good quality, but I did not immediately apply it to my car. When I found the time to glue the strip I found that it was far from good quality. The edges are rough, unevenly trimmed and jagged with a lot of dirt clinging to the edges. I stuck a test strip on one of my doors and not only did dirt get trapped under the strip, but the glue left a brown stain around the edge. When I…