Walker 31902 Hardware Flange Repair Review

This will work for a quick fix, but for a permanent fix get welded two piece blocks from the muffler store, they'll pay the same dollar and they usually come in stock.

Flange did what it was supposed to - helped me reassemble a broken exhaust on my 1999 Cavalier on flex pipe. The problem wasn't with the kit, but with the fact that the pipes stayed where I wanted them to during assembly! In general, after assembly everything worked.

Screws could not be used due to wrong thread size. I had to buy bolts and nuts from auto parts. Spacers were not used. Springs are ok Couldn't mount on manifold just not enough room to put hand between tube and frame. You can weld them around the pipe after installation, but I used epoxy to hold them together. I used them on my 1991 4WD 10 Blazer to connect the exhaust to the header. I saved some money by not going to the muffler shop.

Some exhaust screws broke on my old truck and the exhaust almost fell off. Instead of trying to replace screws by drilling in a small space, I bought these repair kits. Worked beautifully. Now the truck is quiet and people don't look around to see where all the noise is coming from. The kits fit perfectly, they are not that difficult to place even if you have to do both sides. I would recommend them to anyone who needs to have their exhaust system repaired.

I would like to give this product 5 stars but unfortunately it didn't fit well and had cheap nuts and bolts. Repositioning the actual holes. I made sure to measure the diameter of the tube and it was definitely the right size, but the design was just bad. The equipment was shoddy and of very poor quality. I ended up having to weld new bolts to the flanges (which I wanted to avoid) and then attach the exhaust pipe. All in all, I would advise Walker to take a good look at the design of this item…

Flange worked great on my Chevy 350. The bolts were fine but the flange rusted along with the nuts. I couldn't use the nuts that came with the flange on the exhaust manifold studs as they were a different thread. Bolts were included but I used studs that were finished in the exhaust manifold. I had to file a few bolt holes to mount it, but it wasn't as much of a problem as trying to get a one-piece exhaust flange. So I'm uploading photos and videos to show you what it looks like. I used a 2…