WeiSen 8x Quick Grip Head Lock & Ride Tie Down Anchor Kit for Polaris Ranger/General Bed UTV ATV - Compatible with All Models Review

Finally arrived Installation was very easy, didn't need to lubricate with liquid soap like others have suggested, went in and tightened very firmly.

Works very well. They hold up just as well as well-known brands. Only thing is very slow delivery, I must have overlooked it when ordering, just got used to the very fast delivery from Revain.

As above. Get ready to change. I had to install a large flat washer and lock washer on the end that goes in the bed hole. In this case, too, it is difficult to stretch the rubber so that it holds well.

They fit well but couldn't be tightened, added a washer to the bottom and was able to tighten well. As they bounced, loosened, tightened, and loosened again, my whips fell out. Qualitatively disappointed

If you don't trail then it's ok if you trail or hit numerous bumps they don't stay in the nest Me and a few people tried, to toughen it up, whatever bump or limb they may have lost.

Easy to install but terrible design and short lifespan. As you can see what it looks like when you buy it and what happens when you use it. He sucked the bottom washer right through the plastic and ruined it. Very disappointed.

These products are a poorly designed version of what others sell resulting in (rubber coated) spring compression holding them in place in holes in the bottom of the Polaris. The problem you will run into with this is that the nut has teeth on the underside that bite deeper and deeper into the rubber without creating the actual compression needed to hold it in place. Genuine Polaris products have a washer on the bottom that acts as an anti-compression point when tightening the top handle. Rather