🔧 Yonico 12343 Router Raiser: Enhance Precision with 2-Inch Adjustment Review

I broke one of my old trusty panel cutters installing a wrong panel door. So of course I immediately looked for a replacement. I chose Yonico because I've had good luck with their CNC bits and I wasn't disappointed. Unlike my old bit set, Yonico has an undercutter, eliminating extra setup and a source of error. Setup was easy and intuitive. I now have two sets of Yonico Raised Panels, an Ogee and a Quarter Circle.

Good value for money. It also loses a few points for bearing fit on the mandrel, accommodating vibrations more than some of the more expensive versions. It takes a little time to get everything working properly, but use the included shims to change the fit (some extra in a plastic bag and some already on the bits between the cutters) and you'll get it where it is. good solid connection. Patience is the key to any joinery installation; Spend your time setting it up and you won't spend much time…

This review is for the Yonico 12343 Set (1/2" handle and surface finisher with raised rounding nozzle). I am a Amateur not a professional carpenter.If I was making cabinet doors all the time I would have invested in a much more expensive set.Other than that as said the handle and chopstick bits were excellent.I have them on a set of solid maple cabinet doors I first set up the router bit by sliding it all the way into my Bosch 1617 router collet (mounted on a table) and then tightening it up…