🔪 Enhance Precision and Detail with the Yonico 13182Q Edging Molding Router Review

Bearing came loose when cutting less than 200 linear feet of use. Very straight cut. I was very happy with the performance. Then there was a small jump and a catch in the last round of three. After switching back on, the cut seems to be easy. Then I noticed that the camp was gone. The bay below was no longer smooth. Not only did the cut move horizontally, but a small edge of the shaft (the stop where the bearing rests?) also interfered with the work. Very disappointed, this shouldn't have…

This large Roman hub of precision bits machined 40' 5/4" edges with a few simple cuts to reach full size on RedOak, no absolute taring of end grain, no surface burn and ready to go Finish after softening super sharp corners with #0000 wool This bit cuts corners on oak wood so precisely you'd cut your fingers stroking it along a freshly cut ogee It's sharp The carbide on This drill still looked like it was straight out of the box. ProcisionBits is my supplier for these types of bits.

I ordered two of these about ten days ago and received them in reasonable time. I am very satisfied with their work and I would recommend this manufacturer to anyone looking for value for money. I bought these to support the nearly 850 linear feet of 2x6 Doug Fir I was preparing for the rails and crossbars on the outside deck. I ordered two because I was pretty sure one was going to get a little boring before I finished my project and didn't want to order a second one. That's how one punch did…