Review on 🔧 Muzata Custom Hydraulic Hand Crimper Tool and Stainless Steel Cable Cutter Combo for 1/8" Cable – Perfect Wire Swaging and Cutting Solution - CR09 & CR03 by Fred Griffin

After much research into the equipment and tools needed to erect a steel wire fence, I settled on ALL the Muzata gear - steel wire, threaded stud turnbuckles, dead ends, ball joints, works. I saw an impressive marketing video and was won over! To ensure compatibility with all "high quality" and expensive fittings, I purchased both a Muzata Custom Manual Hydraulic Press Tool and a Muzata 18" Press/Press Tool. - taking the drag out of the project - the part I was looking forward to - using a 45 ton hydraulic swaging machine on small steel bolts. I was ready to crush her! small steel pins. I rocked and rocked and leaned on her with my 200 pounds to no avail. I could have made a more serious dent on a small bolt with my teeth, it was ineffective. I called for a second tool, which I bought in the "unlikely" event that the famous hydraulic tool failed. An 18-inch Muzata hand press came from the arsenal. Although it was a great looking machine with lots of "muscle", it also took a very small bite when I finally got it to open its jaws! My molars are stronger again! The small steel end pin would not move. After almost an hour of persuading these two Muzata champions to fight harder and remember the marketing video, I threw in the towel and grabbed my father-in-law's veteran vise and anvil and broker's hammer. (See photo). One hit on the classic anvil and it was a knockout! I'll leave the moral of the story to you. You can choose between two gorgeous muscular muzata weaklings for $169.98 ($79.99 and $89.99) plus shipping and tolls, or a $15 hammer and $20 anvil that works! Alternatively, just use your molars! Much luck!