After some work, I mainly only use it for prints with a large underside that is difficult to remove from the glass. Otherwise I use normal glass mirror tiles. The biggest issue with this finish is actually an issue with the printer itself. The CR-10 uses a metal core circuit board as the base of the build platform, which is notoriously not flat. On my printer, even with the platen center raised and the 9-point ABL, this removable surface still imparts enough bottom layer unevenness to cause an uneven first layer. Maybe I should have put it on the glass. I might try that if I can pull it off without damaging it. In addition, the surface is easily damaged and has a permanent nick in the center due to limit switch failures and Z-house height issues (neither are magnetic surface failures, but care must be taken with them). Another annoyance is that the textured surface tends to hold residue from previous prints, so I got some smudges on some prints with light threads. black on the underside of the previous black print. Other black prints were left with a hazy residue showing the underside of other earlier prints. On the plus side, it tends to separate easily from finished prints, which is why I still use it for large base prints. Otherwise, a smooth, perfectly flat surface is much more beneficial and gives much better results.
BIGTREETECH SKR 3 EZ Control Board 32Bit New Upgrade Silent Board Support EZ2209/ EZ5160/ EZ2130 Stepper Driver Compatible TFT Series Touch Screen, DIY For Most FDM 3D Printer (With 5PCS EZ2209)
7 Review
BIGTREETECH TFT35 V3.0.1 Graphic Smart Display Controller Board For 3D Printer Ramps 1.4 RepRap 3D Printer Can Select Two Work Modes
13 Review
Befenybay 2020 Upgrade: X-Axis Synchronous Belt Tensioner For Creality Ender-3/Ender3 Pro/Ender3 V2/CR-10/CR-10 V2/CR-10 V3/CR-20 Pro โStraighten And Stretch For Enhanced Performance
50 Review
Pack Of 5 TMC2208 Stepper Motor Drivers For 3D Printers, DORHEA V1.2 Module With Heat Sink And Screwdriver For RepRap, RAMPS1.4, MKS, Prusa I3, Ender-3 Pro Controller Boards
19 Review
๐ต IFUN 3D Rapid Resin - Low Odor Photopolymer Resin for 405nm LCD 3D Printer - Fast Curing, Standard Rigid Formula - Sky Blue, 500g
5 Review
Flashforge Adventurer 3D Printer with Detachable Precision Leveling System
6 Review
UV Curing Standard Photopolymer Printer by IFUN
5 Review
Economic Ender 3D Printer DIY Kit With Resume Printing Function, Large Printable Area Of 220X220X250MM By Creality 3D
18 Review