Needed something to remove the timing belt pulley from the 8mm brushless shaft motor for my electric skateboard. It worked but I had to make an extra shaft to slide it through. I used a 5/16 cut screw. This is because the tip is short and tapered. This is not the product's fault as I used it for something else. However, I have 2 problems: the wings that stick to the ground are not very long so they don't stick too much and slide off. I solved this by using a C-clamp to connect them together so they don't separate as the two included side screws didn't help. In general, it works, but requires some ingenuity
Fully Assembled CR-V Steel 8-Inch 3-Jaw Gear Puller For Easy Removal Of Gears, Pulleys, Bearings, And Flywheels - DURATECH Gear Puller Tool
25 Review
💪 Get Efficient Hub Removal with OTC (7394) Universal Hub Puller
11 Review
🔧 11.5 Inch ABN Metal Relay and Fuse Remover Tool - Auto Fuse and Relay Puller Pliers for Better Automotive Maintenance
9 Review
🔧 Astro Pneumatic Tool 78825 25-Piece Master Front Wheel Drive Bearing Puller Set with Grade 8 Drive Bolt
9 Review