Review on 🔦 Eufy by Anker, Lumi Stick-On Night Light, 2nd Gen Warm White LED, Motion Sensor, for Bedroom, Bathroom, Kitchen, Hallway, Stairs, Energy Efficient, Compact, 3-Pack by Stephanie Butler

My main complaint can be both for and against. Once you stick them on a painted wall, they will NOT come off. I've found the problem with these is that after a day or so you realize they need to be moved or aren't working as you initially intended. You can't move them without seriously damaging the wall. At first I tried sliding the butter knife down to avoid damaging it, but that didn't work. I tried several different methods after the first failed attempt and got almost the same results each time. Also, sticky pads are completely useless once you've removed them, which you'd expect, but designers should also keep in mind that most people may need to move them at some point. If you have extra double sided tape you can dispose of it elsewhere, but at this stage you are attaching the paint and drywall 😒 The second complaint is that the lowest brightness setting isn't that low. In fact, in the middle of the night, I think the lowest setting is very bright. Actually, there should be a lower setting. The third complaint can also be considered both for and against. The motion sensor is good. Too good. I placed one in the hallway and it picked up motion from three different bedrooms that were over 10 feet apart, resulting in an unwanted trigger. This is a problem when you put young children to bed and try to sneak out. 😁 I also had one about 15ft from the main bathroom and it picked up movements in bed in the middle of the night and just rolled over to adjust to the bed. Again, this could be a plus for you, but in my case it wasn't. If you know where you want to place them and don't plan on moving them, and my cons are your pros, then this is probably for you. The build quality seemed good.