Bosch makes good parts so I bought it without hesitation when I saw this unit. When I received my part today, it was installed in just a few minutes. I spent a little more time unplugging the power connector from the old part so as not to damage it. You need to place a small flathead screwdriver on top of the latch and push it down, then gently pry it off the connector. I also stuffed it with paper towels before removing it from the engine and I only opened it slightly until the pressure was released so it wouldn't splatter all over the place. I also noticed where the fuel was leaking through the old o-rings, so I cleaned up the assembly area before installing the new part. I lubricated the new o-ring with AC oil intended for seals to keep it from cracking when installing. After installation I ran the engine, it runs smoother and comes out of the cold circuit much quicker than before, but I can't attribute any of this to the sensor as the temperature is warmer today.
820Pcs Car Push Retainer Clips & Fasteners Assortment - Ford GM Toyota Honda Chrysler BMW Benz Nissan Subaru Audi Mazda
32 Review
Replace Car Bumper Clips: GOOACC 100Pcs For Nissan, Mazda And Infiniti, Including Fastener Remover
33 Review
2007-2017 Jeep Wrangler JKU 4 Door Sunshade Mesh Top Cover - Durable UV Protection With US Flag Design - Voodonala
31 Review
Off-Road Fender Flares For Jeep Wrangler 2007-2018 JK & JKU Unlimited - Heavy Duty Flat Textured Steel Mud Guards In Black (Set Of 4) By Hikotor For Front And Rear Replacement (2 Or 4 Door Options)
47 Review