Review on Enhanced Horizontal Holding Capacity of Stainless Release by Larry Morris

I do what I'm supposed to do. This is a small clip, some will say it is a miniature. The black rubber tip is pressed onto the Phillips screw. So far, so good. Clamped onto the finished wood in my case, the rubber stuck to the finished wood and pulled away from the screw. There doesn't seem to be a way to put this back on the screw. The wood finish was a well dried wood primer. After the two pieces separated, the rubber piece began to fall off the primed wood. Recovering from the jammed distortion, he simply broke free and fell to the ground. So the adhesion was low. The clamp is used to close the hatch of the attic ladder. Clamps spend a long time in the locked state. I love the stainless steel finish and as a visible piece in my home I know it will not age to an old gray oxidized state over the years.