Review on HATCHBOX 3D Printer Filament - 1Kg Spool, 1.75Mm Wood Filament With +/- 0.03Mm Dimensional Accuracy by Joshua Johnson

Had no issues printing this on the Ender 3 v2 besides needing some glue stick on the bed to keep it stuck down (as expected with wood). Even using a cheap knockoff .6mm nozzle this stuff prints nice and clean. If it helps anyone out, for the print pictured I used the following slicer settings:-0.2 mm layer height (.3 initial)-185° C nozzle (others have said higher but I found this works best with least stringing for me, your mileage may vary)-55° C bed-100% flow for all areas-65 mm/s print and infill speed-32.5 mm/s wall and top/bottom speed-162 mm/s travel-20 mm/s initial, 100mm/s travel initial-5 mm retraction @ 65 mm/s-no Z hop-no fan first layer, 100% by third layerAlso, if you leave this stuff sitting in your hot end, nozzle with the temperature on, it WILL burn up and clog it, so be careful not to leave it in there for too long between prints, etc.Overall, this is my first time using this sort of filament and I think I will have to order more! Great results with a unique look and not very difficult to print. I have not tried staining or sanding at all quite yet. Would recommend!