Review on Delphi FG0375 Fuel Pump Module by Jeremy Tyson

I have received an official Delphi unit although this should not be a problem. It's just that some reviewers said they had an on and off brand. goes against you ----1) The exhaust pipe and muffler assembly needs to be disconnected from the engine manifold - and with rusty little bolts - this is a problem for the burner, repeated heating and cooling cycles and judicious use of electricity, so how about that Screws do not break in hard-to-remove places. Then the wiring has to be replaced just to get a new connector that fits into the pump-injector fitting. TYPICAL ---> The original pump failed if it ran to the point of empty or consistently below 1/4 of the tank. This will eventually destroy the pump and then you will have to replace it. Quick disconnects require a little understanding to remove the old ones and install the new ones. Examine the new fittings to see what you're dealing with here, otherwise you'll end up fumbling around for hours trying to unscrew them. I still need it! The first Delphi unit I received was defective and the company sent me a new replacement quickly! Even with Corvid-19 - things went pretty well. It's a good price - and if you want it delivered by UPS or Post - then this is for you. You'll also need a few tools and a couple of coasters - etc. But you'll save a wheelbarrow full of $20 bills if you don't go to the dealer (ouch!) or other store. The quality is there - the product works and if you take your time - everything will be fine!