Review on Thermaltake Suppressor F1 Mini ITX Tt LCS Certified Cube Computer Chassis - Black by Goro Honda ᠌

Everything didn’t fit into the comment section, so it’s like that. Mat. ASUS B350m microATX board, ASUS RX560-O4G video, Xilence M403 cooler 1. We dismantle and throw away the sled for disks, 2. Trying on a mat. and video boards on a shelf in the case, note how much you need to cut under the motherboard and under the video card, 3. Cut out: it turns out that you need to cut 5 centimeters under the motherboard (straight to the edge of the case), a couple of centimeters under the video camera (cut off part of the ventilation grille). It is better to cut with an electric jigsaw, do not take wire cutters, you can also use a hacksaw, but it is not very convenient - it will go to the side, the cut will be at an angle (but if there is no jigsaw, it will roll anyway), 4. We put the bar from the mother, and the board itself on the shelf. We mark the holes on the shelf for fastening. The microATX has 3 holes at the bottom of the board, the rest fall into an empty place. We remove mother, we drill. 5. We take bolts m6x20 (it can be both longer and narrower, which is available). We insert it into the holes from the bottom, tighten it with a nut from the top, then a washer and another nut, such a "buter" is just under the existing 4 racks so that the board lies on them, 6. Isolate the existing racks, I pasted the blue one on them! (required :) ) electrical tape, 7. Before installing the PSU and if you have a 2.5 disk, take it and screw it on the left side (when viewed from the back of the case) onto the shelf in a vertical position. There are holes in the shelf, of course they do not coincide with the holes in the disk, therefore it is better to drill under the second bolt (I scored and instead of drilling I glued it on a 2-sided electrical tape), 8. If there is a 3.5 disk, then it can be hung on the same side directly on the wall (in the upper part! Where is the motherboard): in the vent. the grate matches 3 holes with a 3.5 disk, if you put it at an angle a little. I screwed it through the dust mesh: I twisted 3 holes in it with a screwdriver and put it on the complete screws with rubber bands, 9. Well, then the assembly: we throw all the cables, put the PSU, "string" the motherboard onto our 3 pins, tighten it with nuts from above, connect the cables and the front panel.