Review on TOYK967GB 2007 2013 Toyota 2008 2013 Sequoia by Black Croom

Nice fit and faceplate finish. The problem is the clips that attach the bezel to the dashboard. The plastic tabs that hold the clips have small side edges that aren't wide enough for the clips to slide inward. I didn't discover this until after the build was ready to fit the radio into the dash. I had to remove the radio from the assembly and cut off the protrusions. I also had to drill holes in the tab so the tab on the clip would hold it in place. I don't know why my manufacturer didn't do that. Relatively oriental solution if you have a Dremel. I wish I had noticed this before the final build, otherwise they will tell you to make changes before that,