Review on Rear Axle Bearing Puller Set for HFS by David Robinson
Do not buy puller sets
Package arrived I was damaged and well packaged but that's where the good reviews end. A 1"-1 7/8" puller was used on a 2000 Jeep Wrangler rear axle bearing. I removed the seal with a seal remover, put the tool on my slide hammer and then after three hits on the slide hammer the tool failed. Then I had to figure out how to unlock the tool and get it out of the axle tube. This product is not built to last and most likely will not last the entire job.
- Some small things
New products
Comments (0)
Top products in 👊 Pullers
🔧 Astro Pneumatic Tool 78825 25-частый набор «Мастер-тягатель на переднее колесо с передним приводом» с набором гаек 8-го класса.
9 Review
🔧 Профессиональный 18212 4" РЕГУЛИРУЕМЫЙ 2 ИЛИ 3-ЩЕЛЕВОЙ ГАРПУН: Беспрецедентная универсальность для эффективного извлечения шестерен.
9 Review
Fully Assembled CR-V Steel 8-Inch 3-Jaw Gear Puller For Easy Removal Of Gears, Pulleys, Bearings, And Flywheels - DURATECH Gear Puller Tool
25 Review
💪 Повысьте эффективность удаления втулки с помощью OTC (7394) Универсального оттяжки втулки
11 Review
