Review on ANVISION 3 Pack 100 250V Button Control by Brent Borseth

My case was to replace the floor dimmer on a quartz halide lamp where I replaced the heating tube with an LED, dimmable LED. I didn't need to dim the LED, and the old floor dimmer seemed to flicker when off, so I decided to replace it with a switch. This worked great in the app. A very nice design but should only be used by those who know how to handle basic household electrical parts. No instructions, but a small inspection makes the installation clear. It would be helpful if the recommended size of the AC cord was included in the description, not only in terms of how it enters the switch housing, but also because the outer plastic sleeve has wire grips where it enters the assembly. Careful inspection will reveal and indicate a disconnected wire. holes just in case. I also agree that it would be wise to pour some solder on the two ends that are going into the main switch. When I finish the next one I'll take a picture of the inside and post it here if no one has done it by then.