Review on 🖨️ Creality Printers Silicone Adhesive - 310x310mmx1.5mm by Scott Tompkins

Added this to my CR-10 heated stage and wow. easily one of the best improvements I've made so far. The bed heats up in seconds, not minutes, hours or unfortunately never. I can now print PETG (Bed Temp 85°C) and ABS (Bed Temp 110°C) with no problems, however this would require the hotend to be on an All Metal rig (MicroSwiss has a great option that I use). Note: In addition to this heating pad, you will need a solid state relay and an insulating sheet. so that it is convenient to "get your hands dirty” and it is convenient to open the CR-10 control unit and work with electronics and ELECTRICITY. Seriously, to make this work, install a solid state relay (SSR) that connects to the power supply that you connect to the control board - this is safe, but can be dangerous if done incorrectly. As I mentioned above, you need an insulating pad for the bottom (bottom) silicone pad so you don't burn yourself. Also, don't expect any useful installation information you see when you literally get a prefed pad and thermistor, that's what you get. Although there are some great video views on YouTube, I have a video from Nexi Tech called "Creality CR-10S Ultimate Upgrade! A 750w heater is installed' - I would give a link but it is being cleaned.