Review on 🚗 Subaru Impreza WRX, WRX Wagon Ignition Coil Pack - Direct Replacement for 22433AA561, 22433AA421, 22433AA560 - Fits 2002-2005 Models by Jessie Burgos

Tips to make installation easier: ( 2002 WRX) (At your own risk, I will not be held responsible for any damage) - Left side: Use a 10mm socket to remove: washer fluid reservoir (pull out the two rubber hoses at the bottom) and battery. Set both sides aside. Remove the clamps from the coils and remove the coils with the 12mm socket. **When replacing with a new spool, insert the spool halfway and then insert the wire back into the spool, this method is easier than inserting the wire after installing the spool (press hard as the connector is tight). Put the coils back in the end and swap out the battery and washer fluid reservoir. Right side: Disconnect the mass air flow meter. Remove the top of the air cleaner housing and set it aside. Remove the lower part of the air filter housing and set it aside. when removing and installing coils. Replace the air filter housing and connect the mass air flow sensor. Check all fittings and check the engine.