Review on 🔪 Amana Tool 47096 Bearing Diameter: A Premium Precision Cutting Tool for Superior Performance by Rudy Santos

I bought this cutter because I was frustrated with my standard end cutter and had end grain problems. I'm trying to make a small gift for my granddaughter's birthday in May and just ruining work. Despite trying every trick I could think of, I found it very difficult to cut the template glued to a 3/4" thick walnut. I even had a couple episodes where the shank just broke when I tried, only 1/16th inches or less.I ordered and received this nozzle last Saturday and I started using it before it even got to room temperature..All I can say about this lure is that it is just amazing - End grabbing is now a thing of the past Even when working against the grain the cutting action of this attachment gives a pretty good end result with no gouging I route on my router table without holding hands I got four new blanks with the manufacturer recommended one with no problems Bit edited. Like I said, this beat is amazing. Too bad I didn't start my project with this bit in my toolbox. It needs a little after that g to be sanded, but it's not bad at all.