These fit the typical SAE 2 pin 12V connectors. However, there are two big flaws:1) you can't thread the wire through the little rings at the end unless you cut the connector off the wire. You are stuck with zip-tying them on or coming up with some other method (and the zip tie will eventually break the rings in the cheap rubber)2) Assuming you figure out a solution to the above, the tethers are cheap and weak (and break especially easy in cold weather). This is the same problem I had with the original cap. Why would I want to replace it with the same thing?I do wish someone would make a replacement with a durable retaining system. or even just sturdy ring or plastic tab on the connector so I could attach my own retaining string.
2-Inch CravenSpeed Stubby Jr Antenna For Mini Cooper Models 2001-2022 - Compatible And Optimized For Improved Search Engine Visibility.
29 Review
Smart lamp Yandex E27 8W 900lm WiFi RGB YNDX-00018
70 Review
Upgrade Your Light Bar With NAOEVO 14AWG 240W Custom Wiring Harness And 6 Modes Light Bar Controller
29 Review
WUPP Waterproof 12 Volt Fuse Block With LED Warning Indicator For Car, Marine, RV, And Truck - Includes Fuses And Negative Bus Fuse Box
27 Review
25Pcs Fender Liner Screws For Toyota Avalon Camry Corolla Scion Lexus - OEM #90159-60498
35 Review
2007-2017 Jeep Wrangler JKU 4 Door Sunshade Mesh Top Cover - Durable UV Protection With US Flag Design - Voodonala
31 Review
Upgrade Your Mazda MX-5 Miata With CravenSpeed'S USA-Made Door Bushings
39 Review
820Pcs Car Push Retainer Clips & Fasteners Assortment - Ford GM Toyota Honda Chrysler BMW Benz Nissan Subaru Audi Mazda
32 Review