Review on 🔥 Enhance Safety with Dragonfire Racing Harness Pass Through Bezel for 14-20 Polaris RANRZR1000XE by Richard Jarvis

I like them, I'm sick of my belts being all over the RZR floor and my shoulders hurting from the belts rubbing against them. But as everyone has said, they don't look perfect. Gaps in the back corners are an eyesore. I put my whole car together and I don't kid you, it was one of the hardest things I've done with it. I spent a few hours on each seat. At least they look good. and works great. I've only done the two front seats, and as hard as it is, I'm going to do the back seats as well. I haven't messed up or cut too far anywhere, so it's all good. Make the notch tight enough to squeeze the insert to insert it. You will end up deforming the insert and having trouble snapping it into place and DO NOT remove the foam from inside the seat. Just follow the instructions and swap out the utility knife for a Dremel if you like.