1 Level
1380 Review
55 Karma
Review on π§ EANOSIC 3-Flute Carbide Engraving Chamfering Tool by Calvin Reynolds
Bad for steel
Used to engrave steel. It is not recommended to use because the tip kept breaking into small pieces and did not give a stable finish. If someone needs to engrave steel I would recommend using a center drill as the engraver. Small burrs remain, which can then be easily sanded.
Pros
- Lots of positive emotions
Cons
- No power
New products
Comments (0)
Top products in πͺ Router Bits
Ultimate Guide to KOWOOD Router Pieces for Woodwork Beginners
3.56
11 Review
Enhance Woodworking Precision with Roundover Milling Rounding Edge Forming Tool
3.45
11 Review
High-Performance Whiteside Router Bits UD2102 Compression for Precise Woodworking
5
10 Review
Wi-Fi router Keenetic Extra (KN-1713), white/grey
4.81
19 Review
