Review on Mount Power Module Arduino MEGA2560 by Peter Alradwan
Good but could be better
The device is OK and as expected. I'm a little disappointed that there are no pull-up resistors on GPIOs 5 and 6, meaning that relays 1 and 2 are on by default when the Pi is powered on. Considering how cheap resistors are I'm sad to see that this is just a copy and paste job and that two such simple components could just be left out and forgotten. I think I have to have an unfortunate operation. on board to disable GPIO5 and 6 during boot.
- Single board computer
- Useless features
New products
Comments (0)
Top products in 🖥️. Single Board Computers
GeeekPi Raspberry Pi Cluster Case with Cooling Fan and Heatsink for Pi 4 Model B, 3 Model B+ & 3/2 Model B
11 Review
Gikfun Screw Shield Expansion Board: Enhance Arduino UNO R3 with the EK7007 Add-On
11 Review
55" TV LG OLED55C2RLA 2022 HDR, OLED, dark titanium
38 Review
🌐 MCIGICM 2 Channel DC 5V Relay Module: Optocoupler Low Level Trigger Expansion Board for Arduino UNO R3, DSP, ARM, PIC, AVR, STM32, Raspberry Pi
11 Review
Another interesting products
Comprehensive 500pcs Laptop Screw Kit Set for 🔩 IBM HP Dell Lenovo Samsung Sony Toshiba Gateway Acer
12 Review
36-Pack Black Rubber PC CPU/Case Fan Screws/Rivets Set for Computer
11 Review
🖥️ Helifouner 450-Piece Computer Standoffs Spacer Screws Kit: Ideal for Hard Drive, Motherboard, Fan, Power Graphics & Computer Cases
10 Review
MacBook Retina 13-inch (A1425, A1502) and 🔩 15-inch (A1398) Bottom Case Screw Set with Pentalobe Screwdriver
11 Review