Review on FH Group FB036BLACK115 Seat Cover (Airbag Compatible And Split Bench Black) by James Trapkin

I could have given a better rating if I had a different car, but that doesn't work in the 05 Acura MDX. My black leather gets very hot in direct sunlight, so I was looking for a quick solution to avoid getting burned on the seats. The material is good quality at best. The front seat covers fit as expected. However, the rear seat covers do not work. My split bench is split into two sides and attached to rails when the passenger side slides to access the 3rd row seats (there is minimal slip on the driver's side even with the seat back folded down). Therefore, it cannot be easily removed in order to attach it as described in the video. So I had to remove the section on the bench's bottom cover so it wouldn't sag too much on one side, and I had to struggle to secure everything under the seats. Overall it didn't look good. Also, there are no holes for you to thread seat belt buckles through without cutting holes. Designed to fit standard bench seats, this cover features seat belts that attach to the bodywork and run between the underside and the backrests of the seats. My car's seat belt buckles go through the seat cushions so they don't fit properly. Putting covers on the backs of the seats doesn't get much better until one of the straps came loose when you tried to tug on it and learned to adjust the backrest to an upright position. Unfortunately you get what you pay for so I'll be sending them back and coughing up seat covers for my car.