Review on Boao Adjustable Stainless Steel Clamps by Sam Lund
Lots of threads suitable for hydraulics, pneumatics and plumbing
I bought this clamp to fix a rattling catalytic converter heat shield. I was hoping the thread would be long enough to reach deep enough. I didn't measure my transducer at first, but I thought it was 6" to 8" in diameter. If this clip is 24 inches long, I'll cut off about 6 inches when I'm done. There were many more threads that could be used if I needed them. A quick estimate will be 50% thread. In theory, you can easily clamp between 4 and 8 inches.
- Pretty impressive
- Drill kit
New products
Comments (0)
Top products in 🔧 Fittings
Joywayus 5/8" ID Hose Barb Hex Union Brass Fitting Water/Fuel/Air With 10 Stainless Steel Clamps (Pack Of 5)
13 Review
12V Brass Solenoid Valve, 3/4" Electric Air Valve For Water, Air, Gas, Fuel And Oil - Normally Closed By Beduan
10 Review
DIGITEN DC 12V 1/4" Inlet Feed Water Solenoid Valve Quick Connect N/C Normally Closed No Water Pressure
14 Review
1 Inch Beduan Brass Electric Solenoid Valve, 12V Normally Closed Air Valve For Water, Gas, Fuel, And Oil
10 Review
