Review on 🔒 Lippert Flex Guard Kit: Ultimate Slide-Out Protection for RVs by Jesus Jenkins

This is a direct replacement for a broken part on our fifth Montana wheel. It's too long for us so I had to cut it to length. Also, it was rolled so tight for shipping that I had to soak it in hot water as much as possible. There are two sets of holes, neither of which fit our RV. Also, the inner set of holes showed rolling damage where the original failed. I made a piece of aluminum strip, mounting screws and washers for reinforcement, using the pre-drilled holes in the flex as a template for drilling the aluminum. The original cable holders were in good condition, removed from the defective part and put on a new one. Now just hope it lasts!