These are fantastic little connectors. The heat activates the shrink tubing, the sealant on each end, and after a while it will melt the solder. You need at least 280 degrees Fahrenheit. I use a desoldering tool because the small fan I use for shrinking isn't hot enough. I also have a reducing nozzle on the desoldering tool to concentrate the flow of hot air. It takes about 15 seconds for the solder to melt completely. Once connected, you're good to go. It is durable and waterproof. I also took a few apart. This requires serious effort. When I finally managed to break the connection, I broke the copper wires. The silicone sleeve stretched almost an inch and the seals didn't dive at all.
⚡️ Amlits Nylon Spade Quick Disconnect Connectors Kit: 100 PCS, Fully Insulated Male & Female Electrical Crimp Cold-Pressed Wire Terminals Assortment
5 Review
🔴 Baomain Red Female Insulated Spade Wire Connectors - 100 Pack, 18-22 AWG, 2.8 x 0.5mm, Electrical Crimp Terminals
4 Review
🔗 Southwire SW-JHK-32 2-Inch J-Hook Cable Support, Holds 80 Cat 5E Wires, Zinc Plated Steel Ceiling Mount, Pack of 50, Silver
6 Review
🔌 TE Connectivity CPGI-208169-2 Non-Metallic Splice Kit in White - Enhanced for SEO
6 Review
Wireless Electronic Ballast Interface Certified
8 Review
💡 Hydrofarm Quantum QT400 Dimmable Ballast for 400W Grow Lights
5 Review
⚡️ Sunpark LC-12014T (1) FC12T9 32W Circline (1) 2D 38W (1) FC16T9 40W Circline (1) FC9T9 30W Circline Lamp Compact Electronic Fluorescent Ballast with Circline Lamp Plug 120V
7 Review
Robertson Worldwide ISL432T8HEMV AH 3P20160 120-277V 50-60Hz High Power Factor 4 F32T8 Linear Lamp Fluorescent eBallast
6 Review