Review on 🔧 Dremel 575 Right Angle Attachment for Rotary Tool - Angle Drill Attachment, Black: Enhancing Precision and Versatility by Chris Lacasse

This is an indispensable tool. So far I've used it for drilling holes, cutting steel, and grinding steel with a stainless steel brush! CAUTION WARNING - USE CORRECTLY OR THE DREMEEL/ADAPTER WILL BE DISCUSSED Once attached, it may feel natural to press down on the Dremel latch. Knob for tightening the collet on the rotary output. DO NOT DO THAT! This creates excessive loads that the shafts and gears are not designed for. You will most likely crack/break the shaft or damage the gears. You will see a small hole near the exit. If you rotate the output shaft 180 degrees you can see the entire hole through the hole. Place the shank in this hole to block the exit while tightening the collet. Then remove the stem to begin.