Review on 🚙 Rugged Ridge 18003.40 Skid Plate Evaporator Canister for 2007-2011 Jeep Wrangler JK/JKU in Black by Glen Elevyn

There is not much to consider here. Installation takes about half an hour and requires no drilling, cutting, or removing factory hoses. All you have to do is unplug the vaporizer tank electrical connector from the back of the tank and remove the factory screws. The canister is then installed in the carriage, the carriage and canister are one piece and bolted back together at the factory. Connect the cable and you're done. I had to remove or move a few zip ties holding the electrical connection to the underbody to get enough slack to route the wire around the back of the sled, but it wasn't that difficult. remember this as soon as you pick up the box. I just wish it didn't lower the ride height (that's why it gets 4 stars) if you look around there are several sleds that do the same thing and actually increase the ground clearance without moving the unit.