Review on Printing Zeelo Fiberglass Rostock Printers Additive Manufacturing Products by Alif Wills

I liked that it was neatly packaged and rolled up tightly. It also looked and felt strong and clean. The only downside is that I have already had to replace the same belt 3 times from the same reel because it stretches in a short time. I admit that I use my printer almost all the time, but I've only had it for about 1.5 months and this is the third time I've used it. I have already checked that my motor and roller are not disconnected and the path is clean and clear. I've noticed that since I print a lot in the middle of the bed and the pieces are roughly the same size, the spot where it started to stretch is the same spot where it repeats around the platen. I can only assume that this constant movement at one point around the reel is the reason. But that's my experience. I've since ordered and received a steel core belt to see if it could handle the prints I made, so it might just be me. And if so, it will at least give you an idea that while this belt looks, feels and performs well, it can also stretch in one spot with constant use and quick movements.