Review on Enhanced Dimensional Stability in Cc3D's Temperature Adaptive Filament by Tyrone Lee

The title says it all but the only thing I don't fault is that body heat doesn't work immediately. In fact, you have to press it pretty hard with your fingers to make it turn pink. Alternatively, if the print is small enough to be picked up, blow on it for a few minutes. In fact, the plastic turns purple again very quickly after you put it on the table. From what I saw in the photos posted, they either just finished printing their model or used a hair dryer/heat gun, put it on a windowsill for a few minutes or similar before taking the photo. I was kind of hoping you would make a slate model just by writing a message with your finger, draw a simple picture and it would gradually turn purple. .