Enhanced Dimensional Stability in Cc3D's Temperature Adaptive Filament Review

The title says it all but the only thing I don't fault is that body heat doesn't work immediately. In fact, you have to press it pretty hard with your fingers to make it turn pink. Alternatively, if the print is small enough to be picked up, blow on it for a few minutes. In fact, the plastic turns purple again very quickly after you put it on the table. From what I saw in the photos posted, they either just finished printing their model or used a hair dryer/heat gun, put it on a windowsill for…

I would say it's really cool but when I touch it it says I'm warm! - Changes the temperature by 85 degrees Fahrenheit. Prints like any other PLA. My printers are in a small enclosed space and it was fun watching the color change as the space warmed up during printing. The bottom of the spool was purple, and as the filament was lifted over the printer where it was warmer, it turned pink. This material changes temperature (and therefore color) fairly quickly, and conduction of heat through the…

I have used dozens of different brands of PLA and printed thousands of jobs on my Monoprice Maker Select v2 (a rebrand of Wanhao i3) and have never Experienced jams that I carry Neither the drill bit nor the cleaning thread could be removed quickly. I was very surprised that after about 2 meters of thread it got stuck and was so bad that it required disassembling the mechanism to fix it. Apparently this is due to a discrepancy between the diameter and/or knots in the material. I didn't want to…