Review on HICTOP Thermistors Sensor Reprap Printer by Cory Mosley
But not working directly
This is not plug and play for Creality CR 10S pro V2 printer. The connector does not have a spring latch like the original and the two protruding leads in this area must be trimmed flush to allow the connector to fit the socket on the circuit board. Without the spring clip, the connector may come loose. A speck of hot glue between a fork and another fork will prevent this. Also, once plugged in, the temperature gauge was as close or as close as possible to the original. Very happy to have it printed again, would look elsewhere or go with real creativity.
- Recommended thermistor setting: R25℃=100K B25/50=3950K± 1%
- Can't remember
New products
Comments (0)
Top products in 🖨️ 3D Printer Parts & Accessories
10Mm X 11Mm Black Plastic Open Type Cable Wire Carrier Drag Chain Towline R18 For 3D Printer And CNC Machines - 1 Meter Length
7 Review
Befenybay 2020 Upgrade: X-Axis Synchronous Belt Tensioner For Creality Ender-3/Ender3 Pro/Ender3 V2/CR-10/CR-10 V2/CR-10 V3/CR-20 Pro –Straighten And Stretch For Enhanced Performance
50 Review
Pack Of 5 TMC2208 Stepper Motor Drivers For 3D Printers, DORHEA V1.2 Module With Heat Sink And Screwdriver For RepRap, RAMPS1.4, MKS, Prusa I3, Ender-3 Pro Controller Boards
19 Review
BIGTREETECH SKR Mini E3 V3.0 Control Board + TFT35 E3 V3.0.1 Graphic Smart Display Panel Board New Upgrade 3D Printer Parts For Ender 3, Ender3 Pro, Ender 3 V2
13 Review
Another interesting products
Flashforge Adventurer 3D Printer with Detachable Precision Leveling System
6 Review
🖨️ ANYCUBIC Assembled Innovation Off Line Printing: Streamline Your Printing Process with Cutting-Edge Technology
5 Review
High-Precision And Stable Creality Ender 3 V2 3D Printer With New UI, Silent Mainboard, Effortless Filament Feed-In, XY-Axis Tensioner, Resume Printing, And Large Build Volume Of 220×220×250Mm
11 Review
UV Curing Standard Photopolymer Printer by IFUN
5 Review