Review on 🔌 Kreg P OAK Plugs Pocket Hole 50 Pack by David Monaco

No, Kreg didn't invent the pocket hole gauge, but they made it easily available to the masses. The pocket hole attachment is a great addition to any shop and to make it even better Kreg has these little plugs that you can use to easily fill your holes when you're done. I remember the last time I read the reviews there were people crying that the earplugs were too long; said they would have to grind them forever after they were glued in. The nice folks at Kreg made it on purpose folks - one size fits all. Most DIYers will likely use a 3/4" base stock, but the pocket hole attachment is great for materials of varying thicknesses, and these plugs are designed for use with thick and thin materials. For 3/4 inch stock, I either set a small cutoff saw at about 30 degrees (place a piece of wood on the backing for the plug to stand up to) and cut about a quarter inch from the thick end of the plug. If I'm ever lazy or just need a stub or two, I'll quickly chip off a piece with my little band saw or flake off. Apply some glue to everything and slide the end cap until it's almost flush. It doesn't get much easier. than.