Basically I needed a pump diaphragm and a shaft. And the pads worked great. The pump check valve happily replaced my control ball (after installation). The float bowl needle and included seat were too long for my application on a F-143 Willys Jeep Hurricane Carter YF carburetor. Might fit a YFA carburetor for other uses, but I can't confirm. But for the money I'm very happy and I have enough parts to run mine. I was able to thoroughly clean the tip and seat of my old needle and it became airtight and didn't flow, so maybe you can do the same.
🚗 New Edelbrock 1405 Performer 4-Barrel Carburetor with Manual Choke, 600 CFM Square Bore and Air Valve Secondary
9 Review
Exhaust fan VENTS 100 Quiet, chrome 7.5 W
10 Review
Exhaust fan Soler & Palau SILENT-100 CZ, gold 8 W
29 Review
Exhaust fan Soler & Palau SILENT-100 CZ, Silver 8 W
41 Review