Review on 🚐 Tow Ready 118521 T-One Connector Assembly: A Perfect Fit for Honda Odyssey Towing Needs by Wade Brooks

I bought this for a 2016 Odyssey SE. The white ground wire should be about 4 inches longer. The problem with the SE is that the vacuum interferes with cable routing. The easiest way is to run the cable over the storage compartment. The ground screw, located on the bottom rear of the car (the one recommended for a trailer and the only one I could find within reach) leaves the wire slack, causing the gray plug to sit in a place where you can't put the control box. The cable between the Honda Vac base and the storage compartment (recommended route on a trailer) requires pulling power and with the Honda Vac hose passing through there is also very little room for the control box which causes the side panel to bulge slightly when newly installed. It's barely noticeable and everything still works and closes properly so I left it with a slight dent. The easiest solution would be to add about 4 inches to the ground wire and then run it across both bays. In this direction, the cable can be laid more easily and there is more space for the box. However, this may limit the range of your 4-pin connector. TLDR: Not recommended for Odyssey 2016 with Honda Vac. Ideal for any other model.