Review on π Quickun Reducer Fitting Reducing Splicer: Streamline Your Connections Effortlessly by Chris Dildine
Predator engines like the 212 need them.
If you're messing around with Harbor Freight gasoline engines, you're going to need them sooner or later, as the fuel tank requires a 14-inch ID fuel hose, and the carburetor side needs a damn 3/16 inch ID hose. Just buy a few of these. You will not regret it. It's a lot easier than trying to draw Mickey Mouse with two different sized fuel lines.
- Type: Repair/weld adapter for barbed hoses. Hose-to-hose adapter with a different diameter threaded connector
- No Instructions
New products
Comments (0)
Top products in π§ Fittings
12V Brass Solenoid Valve, 3/4" Electric Air Valve For Water, Air, Gas, Fuel And Oil - Normally Closed By Beduan
10 Review
Upgrade Your Draft Beer Kegerator With The TerraBloom CO2 Keg Pressure Regulator - Dual Gauge Heavy Duty Unit With Safety Features
16 Review
High-Quality QiiMii Stainless Steel Sanitary Clamp With Silicone Gasket - 2 Inch, Single Pin Tri Clover Design
16 Review
6 Pack Miahart Adjustable 304 Stainless Steel 4 Inch Hose Clamp Duct 91Mm-114Mm Worm Gear Pipe Clamp For Automotive, Mechanical Agriculture.
18 Review
